Board for headlining

My headling boards had died ... too much water had destroyed them ... attached is the files I used to make new ones.



Please note: these are exact for MY boat. Ther are not symmetrical, I don't know if they work for YOUR boat. It seems on my boat the panel for the connections to the mast is not in the centre of the boat ... it is 20mm to the port side ...

DXF file: www.dropbox.com/s/ptwybhh8lyy0cev/frontH...g3Composite.dxf?dl=0

And .. before:



After;





All new lights, LED naturally. Woodwork has been taken back to the natural state and coated with epoxy.

I will make 2 x new piece for the air vents, this time I will change the design so the air vent tube is inside the wooden piece, not outside. This way any water comes to the floor, not to the ceiling.